Restoring The Factory Settings - Caple CM460 Bedienungsanleitung

FOR EXPERT USERS ONLY:
PROGRAMMING THE GRINDING TIME
The grinding time for strong coffee is programmable and
medium and light coffee are calibrated accordingly.
To enter programming mode, when the machine is in
standby mode:
• press the START/STOP button for 5 seconds; the
LED s on the upper left line light up to indicate the
grinding time;
• to increase the time, press the coffee regulation
button and to, decrease it, the START/STOP button.
At the end of the operation, just press the on/off button
to exit and confirm the changes.
NOTE If the qauntity of coffee has been incorrectly
adjusted preventing dispensing, the coffee machine
will perform checks until the correct dispensing is
achived. The machine will begin grinding the coffee
and the general alarm symbol will illuminate. This
proceedure terminates then the coffee is dispensed
and new coffee parameters are then stored. You may
be asked to perform a cleaning operation, if so
please proceed with this (see chapter 7). If the
problem persits please contact Caple Service.
12. PROGRAMMING THE QUANTITY OF
COFFEE IN THE CUP
All the cycles have a preset quantity, except for water
and steam.
The machine is already calibrated at the factory to
dispense the ideal quantity of coffee for an espresso
cup.
While dispensing the beverage, you can stop dispensing
before the preset time by pressing the START/STOP
button.
The procedure for programming the quantity of coffee,
and other beverages, in the cup is as follows:
• press the coffee key for 5 seconds until the LED
flashes.
• press the START/STOP key to start dispensing. The
two LEDs flash for its duration.
• press the START/STOP button again when the
desired quantity is reached.

Restoring the factory settings

When it leaves the factory, the machine is calibrated
for Italian-style espresso coffee and German-style
stretched coffee.
• If you need to restore these standard values, you
must place the machine in standby and press the
coffee regulation button for 6 seconds.
• You will see all the LEDs, except on/off, flash for 5
seconds; after that time, the board has stored the
default values.
• Press the on button and the selections will now use
the factory values.
The standard values are only relative to the
quantity of water necessary for each single
dose.
27
GB