Cleaning The Filter; Accessories - SOLAC Hyperdinamic Gebrauchsanleitung

Clean the appliance.
•

ACCESSORIES:

Air concentrator accessory:
This accessory is used to concentrate the air
•
flow into one specific area.
Attach the unit to the product by pressing until
•
you hear a click.
Diffuser accessory:
This accessory is used to harmonize the air
•
flow into one specific area.
Attach the unit to the product by pressing until
•
you hear a click.
SAFETY THERMAL PROTECTOR:
The appliance has a safety device, which pro-
•
tects the appliance from overheating.
When the appliance switches itself on and off
•
repeatedly, for reasons other than the ther-
mostat control, check to ensure that there are
no obstacles that impede correct air entry or
expulsion.
If the appliance turns itself off and does not
•
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
Disconnect the appliance from the mains and
•
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
•
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid
•
or base pH such as bleach, or abrasive pro-
ducts, for cleaning the appliance.
Do not let water or any other liquid get into the
•
air vents to avoid damage to the inner parts of
the appliance.
Never submerge the appliance in water or any
•
other liquid or place it under running water.
If the appliance is not in good condition of clean-
•
liness, its surface may degrade and inexorably
affect the duration of the appliance's useful life
and could become unsafe to use.

CLEANING THE FILTER:

The air inlet filter should be cleaned periodica-
•
lly for proper operation of the device.
To do this, turn the filter counterclockwise.
•
Clean the filter and remove any dirt or hair.
•
Put the filter back in its place and turn cloc-
•
kwise
EN