Troubleshooting - Kress KG633E Serie Bedienungsanleitung

TROUBLESHOOTING

Symptom
Machine turns on but it does
not draw any water or there
is not sufficient pressure.
Multi-spray nozzle leaks.
Outlet pressure increases
suddenly.
Machine drains out water
after stopping.
Soap accessory cannot
spray out any detergent.
Machine does not start.
Machine pressure is not
consistent.
Machine stops automatically.
Possible causes
Power nozzle is too high from the
water source surface.
Hose filter is blocked.
The users garden hose is not well
connected to the machine.
Hose adapter looses.
The filter screen is missing. (See Fig.
P1, P2)
Pump, hose, or other parts are frozen
due to outside temperatures.
Hose kinks.
The nozzle pattern does not spray
correctly.
Fixing nail of the multi-spray nozzle
loosens.
Multi-spray nozzle is blocked.
There is water remaining in the lance
and pump after stopping.
Blockage in the soap bottle.
The battery pack is not attached well.
Battery pack is empty.
Defective battery.
Additional air could be sucked into
the machine.
It is at low pressure setting.
Battery pack is empty.
The multi-spray nozzle is blocked.
The current protection is activated.
Solution
Lower the machine below
5ft/1.5m.
Take out the hose filter and rinse
the parts with clean water. (See
Fig. N1, N2)
Check and reattach the garden
hose tightly.
Tighten the hose adapter securely
with a spanner.
Contact Kress service agent to get
a filter screen.
Wait for the pump, hose or other
parts to thaw.
Straighten out the hose.
Make sure the nozzle pattern
symbol aligns with the indicator
mark on tool.
Tighten it with a hex key.
Replace with a new multi-spray
nozzle.
Drain all the water completely
before storage.
Clean it with fresh water.
Reinstall the battery pack.
Replace with a new battery pack
or recharge the battery pack.
Replace with a new battery pack.
Check connection between the
hose adapter and the hose.
No action need.
Replace with a new battery pack
or recharge the battery pack.
Remove the multi-spray nozzle
and turn on the machine. If the
machine works normally, replace
with a new multi-spray nozzle.
15
EN