Parts; Before First Use; Charging The Battery; Using The Hair Clipper - Ideen Welt HS329 Bedienungsanleitung

3. PARTS

4. BEFORE FIRST USE

Attention! The battery should be charged for 12 hours prior to first use. Noncompliance with this
instruction can lead to a shortened battery life.
1. Remove all parts from the packaging and check them for damages. Do not use any damaged parts. Risk of
Injury!
2. To recharge the battery, follow the instructions in the following section "Charging the Battery".

5. CHARGING THE BATTERY

1. If the clipper functions poorly or if the blades no longer move, the battery needs to be recharged. The battery
must also be fully charged prior to first use. Always recharge the battery fully in order to maintain the life of the
battery. A battery that is not fully charged will shorten the battery life and will reduce the operating time as well.
2. Unwind the adaptor (5) connection cable completely and connect it to the recharging station.
3. Place the hair clipper (3) on the recharging station (4), paying attention to both poles. The hair clipper can only
be placed onto the recharging station in one direction.
4. Connect the adaptor to a suitable power socket.
5. The red recharging indicator light underneath the on/off switch ON/OFF (2) lights up. Make sure that the on/off
switch ON/OFF is in the lower position (OFF position) while the battery is recharging, otherwise the battery will
not be recharged.
6. The charging time for a complete recharging process takes approx. 4-6 hours. The charging indicator light does
not go out when the battery is full.
7. A fully charged battery has an operating time of approx. 40 minutes.

6. USING THE HAIR CLIPPER

Attention! Follow the Safety Instructions carefully as well.
Attention! Before each use, check the device, recharging station and adaptor with connection cable for
damages.

6.1 LUBRICATING THE BLADE

Before cutting hair, put a couple of drops of lubricating oil (6) onto the blades and let the hair clipper run for a few
seconds. Turn the hair clipper off again and wipe off excessive lubricating oil with a cloth.
1. Cutting blade holder
2. On/off switch ON/OFF
3. Hair clipper
4. Recharging station
5. Adaptor
6. Lubricating oil (blade oil)
7. Cleaning brush
8. Comb
9. Hairdresser shears
10. Attachment comb 15 (15 mm)
11. Attachment comb 6 (6 mm)
12. Attachment comb 1 (1 mm)
13. Attachment comb 18 (18 mm)
14. Attachment comb 12 (12 mm)
15. Attachment comb 9 (9 mm)
16. Attachment comb 3 (3 mm)
7