Getting Started - Chuango SPS-260 Bedienungsanleitung

EN
Usage

Getting Started

1. Load the 9V battery.
2. Set the volume and duration of the siren.
3. Start to use by pressing the power button on.
Note: The battery is used to charge the 18650 battery in case it is out of
power/with low power after a long time storage. Use the 9V battery to
charge 18650 for 12 hours and then remove 9V battery before installation
When installed as part of a
chuango Alarm System, the
Siren must be paired to the
Control Panel only.
The Siren will sound and the
strobe lights will flash upon
alarm activation. Disarming
the System will stop the siren
sounding. If not disarmed the
Siren Status Indicator will flash
once every 2 seconds for one
hour (visual notification of an
alarm event).
Pairing to a Control Panel
1. Press the Learn Button on the
Solar Siren (0.5 seconds), the
siren goes into Learn Mode after
one beep is heard.
2. Press the Arm or SOS Button on
the Control Panel(or press Arm
on App if the panel does not
have a button).
3. The Siren is paired with Control
Panel successfully after a second
beep.
4. If two beeps are heard, it is
already linked.
To give up pairing the Control
Panel, press the Learn Button
(before step 2 is done) again to exit
Learn Mode after one beep.
When installed as Siren
only Alarm System (without
control panel). All of the
Alarm Accessories must be
paired to the Siren.
The Siren will sound and the
strobe light will flash upon
activation of a connected
Accessory.
Disarming the System will
stop the siren sounding. If
not disarmed the Siren Status
Indicator will flash once every
2 seconds for one hour (visual
notification of an alarm event).
Note: Press and hold the pair button of the wireless siren; the connection
between the wireless siren and control panels (or accessories) is deleted
when you hear a beep from the wireless siren.
Pairing with Wireless Accessories
1. Press the Learn Button
(0.5 seconds), the system goes
into Learn Mode after one beep
is heard.
2. Press the Test Button on the
additional Accessory or trigger
the Accessory once.
3. The Wireless Accessory is
learned successfully after a
second beep.
4. If two beeps are heard, the
accessory is already linked.
To give up pairing the Accessories,
press the Learn Button (before step
2 is done) again to exit Learn Mode
after one beep.
EN