Troubleshooting - Lampa FC-30 Gebrauchsanweisung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

7. TROUBLESHOOTING

ISSUES

Refrigerator doesn't work •

Refrigerator

compartment is too

warm

Food is frozen

There is a "waterflow"

noise inside the

refrigerator

There are waterdrops

around the refrigerator's

casing and/or door gap

The compressor is slightly

noisy when starting

Code F1 is displayed

Code F2 is displayed

Code F3 is displayed

Code F4 is displayed

Code F5 is displayed

Code F6 is displayed

Codes F7 or F8 are

displayed

CAUSES / SUGGESTIONS

Make sure the appliance is switched on.

•

Check if the plug is well connected into the socket.

•

Check if the fuse has blown*.

•

Check if the power is supply is malfunctioning or defective.

•

Switching the fridge ON and OFF frequently may cause some delay in the

compressor's functioning.

•

The door is opened too frequently.

•

A large amount of warm or hot food was stored.

•

The refrigerator has been disconnected for a long time.

The temperature was set too low.

No need to worry, it's a normal phenomenon caused by the flow of the refrigerant.

No need to worry, it's a normal phenomenon, the moisture will condense into water when

it comes into contact with the cold surface of the refrigerator.

It is a normal phenomenon; the noise is reduced as soon as the compressor starts

functioning stably.

Possible cause: low voltage.

Adjust the battery protection mode from High to Medium or from Medium to Low.

Possible cause: the condenser's fan is overloaded.