Functioning - Lampa FC-30 Gebrauchsanweisung

5. FUNCTIONING

• Power Supply: connect the appliance to either DC 12/24V or AC 220-240V power supply (use the
included dedicated AC 220-240V adapter).
• Display Screen Initialization: connect the appliance to a power supply, the cooling box will emit a
long beeping sound and the display will be on for 2 seconds before entering in normal operating mode.
• Power ON/OFF: Press
compressor has stopped working or there is a delay in its functioning; if the light is green, the compressor
is on and running).
• Temperature Setting: press
appliance to save the required temperature (Note: the temperature displayed is the current required
temperature, after setting it the appliance will need some time to reach the set temperature).
Temperature setting range: -20°C~20°C/-4°F~68°F.
• Cooling mode: when the appliance is ON and running, press
mode, the ECO/MAX light is red), press it again to switch to ECO mode (energy saving mode, ECO/MAX
light is green). (Factory setting is HH).
• Battery Protection Mode: when the appliance is ON and running, press
screen flashes, then press it again to select the required protection mode: H3 (High), H2 (Medium), H1
(Low). (Factory setting is H3).
• Voltage reference:
The voltage is only a theoretical value, as it may vary depending on different conditions and scenarios.
H3 should be set when the appliance is connected to the car's power supply, while H2 and H1 when the
product is connected to a portable or a back-up battery.
• Temperature's Unit of measure: Turn OFF the appliance as instructed above, then press
seconds until E1 shows up on the display, then switch to E5 by pressing multiple times on
E5 mode press or
• Reset: Turn OFF the appliance as instructed above, then press
the display. When in E1 mode, press
display.
to switch the appliance ON or OFF. (If the POWER light is red, either the
or to set the required temperature. It will take 3 seconds for the
to select Celsius of Fahrenheit. (*Factory setting is °C.).
simultaneously for a few seconds until "888" appears on the
to switch to HH mode (quick cooling
for a few seconds until the
for 3 seconds until E1 shows up on
EN
for a few
. When in
19