cecotec bolero COOLMARKET COMBI 250 WHITE D Bedienungsanleitung Seite 69

Fig. 18
28. Lower hinge pin
Fig. 21
29. Upper door's upper-left hinge
Fig. 22
30. Upper door connector
31. Refrigerator connector
32. Refrigerator connector
Fig. 23
33. Self-tapping screw
1. Open the door, remove the door shelves (to prevent any damage) and then close the door.
To remove the shelves, slightly press the shelf and move it upwards. Fig. 6
2. Unscrew the screw on the upper-right hinge (1), then remove the upper hinge cover (2).
Carefully unplug the electrical connector (3) underneath. Fig. 7
3. Press the side of the door switch (4) and pull it upwards to separate it from the upper-right
hinge cover (2). Insert the door switch (4) into the upper-left hinge cover (5) (included in
the plastic bag). Keep the upper-right hinge cover (2). Fig. 8
4. Unplug connectors (A) and (B). Then unscrew the screws (6) with an 8 mm drill or a spanner
and remove the upper-right hinge (7). Then fit the connectors (A) and (B) into the hole as
shown in figure 9. After this process, the refrigerator door will be unstable. Be sure to hold
it in place so as not to damage it. Fig. 9
5. Carefully lift the upper door to remove it from the middle hinge. Then place the upper door
on a soft surface with the inside facing upwards. Fig. 10
6. Insert the right-hand screw gap cover (9) (included in the plastic bag) into the upper-right
side where the upper-right hinge was located. Then, remove the left screw gap cover (10)
from the upper-left side of the refrigerator and put it away. Fig. 11
7. Remove the upper-left side door cover (11) and remove the connector (12). Remove the
upper-right side door cover (13) and place the connector (14) inside. Replace the upper side
door covers (11 and 13) Fig. 12
8. On the upper door's right side, unscrew the screw (15) and remove the dowel (16) from the
door stop (17). On the upper door's left side, insert the left door stop (18) and the left dowel
(19) (included in the plastic bag) and secure it with the screw (15). Keep the right door stop
and dowel. Fig. 13
9. Use the Allen key (included in the plastic bag) and a Phillips screwdriver to loosen the
screws and remove the upper-right hinge from the lower door. Then carefully lift the door
up and remove it. Then carefully lift the door up and remove it. Fig. 14
10. Place the lower door on a soft surface with the inside facing up. On the lower door's right
BOLERO COOLMARKET COMBI 250 WHITE D / INOX D
ENGLISH
69