Detection Range; Working Mode - Chuango PIR-910 Bedienungsanleitung

EN
Tamper switch: Once the case is opened in working mode, the
tamper switch is triggered and then generates an alarm signal.

Detection Range

Top view
Pet-Immune Function Illustration
2-2.2m
1m
2-2.2m
3m 6m 8m
2m
Side view
8m
IMPORTANT: If you keep a pet at home, make sure the detector is installed
at the upright position to achieve pet-immune function.

Working Mode

Testing Mode
Press the test button, the detector enters testing mode and
detects once every 10 seconds. After 3 minutes, the status
indicator blinks twice, and the detector switches to power saving
mode.
Power Saving Mode
If the PIR motion detector detects movements twice in 3 minutes,
it automatically goes into a sleep state. If there is no movement
detected in next 3 minutes, it will switch from sleep state to arm.
During the 3 minutes, the detector won't be active and send
any signals to the control panel. As long as there is a movement
detected within 3 minutes, the duration of power saving mode will
be extended.
EN