D-Link DCS-4603 Installationsanleitung Seite 8

Connect the power and Ethernet cables, or just the
Ethernet cable if you are using a PoE connection.
To adjust the camera's angle, pull the black inner
cover and remove it from the camera.
Loosen the adjustment screw on the side of the
camera, then retighten it after moving the camera to
the desired angle. You can also rotate the camera
by grasping the camera and turning it left or right.
When you are done adjusting the camera's angle,
put the inner cover back into place.
Note: The camera has a limited range of motion; if
it stops when you are adjusting it, do not attempt to
rotate or tilt the camera any further in that direction.
Reattach the camera cover.
6
D-Link DCS-4603 Quick Installation Guide