Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Possible problems and solutions
Problem description
The dust collector
does not turn on
During operation,
dust leaves the filter
bag designed to
collect dust
Dust leaves the filter
bag after its cleaning
The dust collector
collects dust only
partially
ENG
Problem source. Solution
Make sure that the outlet you connected the device to is in good working
condition. Make sure that the mains cord is inserted into the mains, the
governor part is set to ON until it locks and the switch is set to ON. If this
does not help to fix the problem, contact the manufacturer via e-mail:
i@max4u.ru
It is necessary to replace the bag with a clean one. We recommend you
to use a clean filter bag every time before you start work and replace it at
least once a day or – if necessary – more often. (See washing instructions
in Section «Care»)
The filter bag fabric has lost its filter properties. Wash and dry it again
(washing instructions in Section «Care»). If this does not help, you need to
replace the filter bag.
•
Install a clean dry filter bag.
•
Make sure that the filter bag of the dust collector is spread evenly
and nothing disrupts the air flow. If not, remove the obstacle or
spread the bag.
•
Try to work so that there are no obstacles between the dust source
and the grill. It is not permitted to shut off the air flow with your
hands or with the hands of the client.
•
It is necessary to chip nails above the grill, in the area located 1.5 cm
from the edge of the grill inside.
•
Try to keep the client's hand as close to the grill of the dust collector
as possible.
•
If all the above-mentioned did not help, reduce the speed of rotation
of a milling cutter (during hardware manicure) to 15000-20000
rotations
Kaitstud / Secured by https://mereneid.eu/
10
Werbung
