Philips PerfectCare Elite Plus GC9666/30 Bedienungsanleitung Seite 14

ENGLISH
16
Problem Possible cause
The iron leaves The surface to be ironed was
a shine or an uneven, for instance because
imprint on the you were ironing over a seam
garment. or a fold in the garment.
The appliance There is not enough water
does not produce in the water tank (the 'water
any steam. tank empty' light flashes).
The appliance is not hot
enough to produce steam.
You did not press the steam
trigger.
The water tank is not placed
in the appliance properly.
The appliance is not switched
on.
The appliance has The auto-off function is
switched off. The activated automatically
light in the on/off when the appliance has not
button flashes. been used for more than 10
minutes.
The appliance Water is pumped into the
produces a boiler inside the appliance.
pumping sound. This is normal.
Solution
PerfectCare is safe on all garments. The
shine or imprint is not permanent and
will come off if you wash the garment.
Avoid ironing over seams or folds or
you can place a cotton cloth over the
area to be ironed to avoid imprints at
seams and folds.
Fill the water tank (see chapter 'Using
your appliance', section 'Filling the
water tank').
Wait until the 'iron ready' light on the
iron lights up continuously.
Press the steam trigger and keep it
pressed while you iron.
Slide the water tank back into the
appliance firmly ('click').
Insert the plug in the wall socket and
press the on/off button to switch on
the appliance.
Press the power on/off button to
switch on the appliance again.
If the pumping sound continues
nonstop, switch off the appliance and
remove the plug from the wall socket.
Contact an authorised Philips service
centre.