Indu-Sol PROmesh P20 Schnellstartanleitung Seite 8

The PROmesh P20 is delivered with the following factory settings:
IP Adress
Subnet mask
Gateway
Username
Password
You can customize them with the Service Tool already installed. Connect your PC to one
of the 20 available ports of the switch. Then perform a device scan with the Service
Tool. Make sure that the field „PROFINET device" is selected under the scan settings.
After you have performed the scan, you can adjust the IP address, the subnet mask, the
default gateway and the PROFINET name of the PROmesh P20 according to your needs.
! NOTE Make sure that the IP address you selected has not yet been assigned. If required, you
can display IP addresses that have already been assigned using the PROscan® Active V2
license software from Indu-Sol.
! WARNING We recommend to change the factory-set password at the 1st login. It is your responsi-
bility to document this password and protect it against unauthorized access
Accessing the Web User
Interface
The device-specific functions of the PROmesh P20 can be configured via an integrated
webinterface. Open your browser, enter the IP address of the PROmesh P20 configured
in the ServiceTool in your browser bar. Alternatively, you can right-click on the corre-
sponding list entry in the context menu of the ServiceTool to select „to website". The
Web UI now opens in your standard browser.
! NOTE Further information on the configuration options and troubleshooting can be found in
the supplied manual on our website:
https://sdx.indu-sol.com/s/fZDLQTyzLPg9RPR
14
0.0.0.0
0.0.0.0
0.0.0.0
admin
admin
ENGLISH
Interpreting LED Displays
LED label Mode Meaning
VDC1 Green Voltage at terminal sufficient
Off Voltage at terminal insufficient
VDC2 Green Voltage at terminal sufficient
Off Voltage at terminal insufficient
Status Green PROFINET connection to the controller
active
Yellow PROFINET connection to the controller
inactive
Error Red Power failure, port error or configured
alarm active
Off No malfunction at the port
Data Green Connection established
Blinking Sending / receiving data
Off No connection established
ENGLISH
15