Cartrend 11158 Originalbetriebsanleitung Seite 32

2. Release the lock-on lever and place the lock-on lever [17] as far on the
tyre valve as possible. Close the lock-on lever in the process.
If the chuck [17] is correctly connected to the vehicle's valve, the pres-
sure gauge [12] will show the current tyre pressure.
3. If this value corresponds to the recommended tyre pressure for the
vehicle you can remove the chuck [17].
4. If this value is below the recommended tyre pressure for the vehicle,
set the On/Off switch [11] to "I" to switch on the compressor.
Note: The compressor can be switched off at any time by switching the
On/Off switch [11] to the "0" position.
5. When the pressure gauge [12] shows the recommended pressure, set
the On/Off switch [15] to "0" to switch off the compressor.
6. Release the lock-on lever and remove the lock-on lever [17] from the
tyre valve.
7. Also check the air pressure with a second pressure gauge to determine
the accurate value. Repeat the process if the desired air pressure has
not been reached.
8. Then replace the valve cap on the tyre valve.
Inflating sporting goods, toys and recreational products
Attention!
Observe the specifications of the manufacturer of the product. Do not use
the compressor to inflate flotation devices!
Attention!
The compressor may be operated for max. 10 minutes, after which the
device must cool down for 10 minutes!
1. First read the product manufacturer's instructions for inflating and the
approved maximum air pressure before inflating the product.
2. Open the product's valve cover.
3. Attach the corresponding valve adapter to the chuck [17] and push it
into the valve of the product. If the valve adapters comes out of the
valve whilst inflating, you will need to push it into the valve with your
hand whilst inflating.
4. Verify the valve adapter is securely connected to the valve by carefully
pulling on it.
5. Set the On/Off switch [11] to "I" to switch on the compressor.
Note:
The compressor can be switched off at any time by switching the On/Off
switch [11] to the "0" position.
6. When the pressure gauge [12] shows the recommended pressure, set
the On/Off switch [11] to "0" to switch off the compressor.
32
Jump Starter