Mounting Instructions; Setting The Time - Roadstar CLR-2950DAB+ Bedienungsanleitung

WARNINGS
The exclamation point within the triangle is a warning sign alerting
the user of important instructions accompanying the product.
The lightening flash with arrowhead symbol within the triangle is a
warning sign alerting the user of "dangerous voltage" inside the unit.
To reduce the risk of electric shock, do not remove the cover. No
user serviceable parts inside the unit. Refer all servicing to quali-
fied personnel.
This unit operates on 230V ~ 50Hz. If the unit is not used for a
long period of time, remove the plug from the AC mains.
Ensure all connections are properly made before operating the
unit.
This unit must not be exposed to moisture or rain.
This unit should be positioned so that it is properly ventilated.
Avoid placing it, for example, close to curtains, on the carpet or in
a built-in installation such as a bookcase.
Do not expose this unit to direct sunlight or heat radiating sources.
English 3 4 English

MOUNTING INSTRUCTIONS

1. Drill a 6mm diameter holes through the underside of the cabinet bottom shelf
using the three points marked on the template.
2. Select the spacer or combination of spacers that fit your preferences, from
the mounting kit.
3. Fix the unit using the screws from the mounting kit.
MAINS (AC) OPERATION
Before switching on make sure that the voltage of your electricity supply is the
same as that indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to
connect this unit to the mains.
This unit is designed to operate on AC 230V 50Hz / DC 12V current only. Con-
necting it to other power sources may damage the unit.
To prevent electric shock disconnect from the mains before removing cover. No
user serviceable parts inside. Refer servicing to qualified service personnel.

SETTING THE TIME

Note: Please make sure that all connections have been ready.
1. In standby mode, press and hold MEM/CLK/MENU BUTTON (8), the Hour
digits will flash. Press SKIP BACK/UP / TUNING -/+ BUTTONS (4)/(5) on
unit or on remote repeatedly to set the clock to the correct Hour, press MEM/
CLK/MENU BUTTON (8) to confirm.
2. Then the minute digits will flash, press SKIP BACK/UP / TUNING -/+ BUT-
TONS (4)/(5) on unit or on remote repeatedly to set the clock to the correct
Minutes, press MEM/CLK/MENU BUTTON (8) again to confirm.
3. The display will show the RTC 12 hours or the RTC 24 hours version. Press
SKIP BACK/UP / TUNING -/+ BUTTONS (4)/(5) on unit or on remote to
choose for the 12 or 24 hour version. Press the MEM/CLK/MENU BUTTON
(8) to confirm.