Technical Data; General Warnings; Correct Usage - Rupes RH253 Bedienungs- Und Wartungsanleitung

TECHNICAL DATA

TYPE
WORKING PRESSURE bar/PSI
AIR CONSUMPTION l/min
SPEED CONTROL
RPM
ORBITAL DIAMETER mm
DISC PAD DIAMETER mm
DISC PAD TYPE
EXTRACTION SYSTEM
WEIGHT Kg

GENERAL WARNINGS

The tool must be connected to a suitable dust extraction system (not supplied).
The safety and accident prevention instructions are reported in
the "SAFETY INSTRUCTION" booklet which forms an integral part
of these documents. This OPERATING INSTRUCTION MANUAL
indicates the additional information required specifically for use
of the tool.

CORRECT USAGE

This tool is designed to be used as a sander. Read all the
warnings, instructions, indications provided on drawings and
specifications supplied with this tool.Failure to comply with all the
instructions provided below may cause serious injuries.
This tool is not intended to be used for metal brushing,polishing
and cutting operations. The use of this tool for unintended
applications may cause hazards and injuries to people.
Do not use accessories that are not specifically designed for the
intended use of the tool or that have not been recommended by
the manufacturer. The fact that an accessory can be fixed to the tool
does not imply that it can be used safely.
The rated speed of the accessory must be at least equivalent to
the maximum speed specified on the tool. Using the accessories at
speeds above the rated one, may cause them to break or be
8
RH253 RH256
6,2/90 6,2/90
320 320
YES YES
0 ÷ 11.500 0 ÷ 10.500
3 6
150 150
VELCRO FACED VELCRO FACED VELCRO FACED VELCRO FACED VELCRO FACED VELCRO FACED
- -
0,750 0,750
projected into the air.
The external diameter and thickness of the accessory must match
the specifications of the electrical tool. Accessories with incorrect
dimensions cannot be adequately protected or controlled.
The configuration of accessories must match the tool. The use of
accessories that cannot be perfectly fitted on the tool may result in
imbalance, excessive vibrations and in the impossibility of controlling
the tool.
Do not use damaged accessories. Before use, inspect all the
accessories. Inspect the supporting pads and verify there are no
cracks, tears or excessive wear. If the tool or accessory has fallen,
verify that it is not damaged or install a new accessory. After
inspecting or installing an accessory, move to a safe distance with
any other person present and operate the tool at maximum speed
without load for one minute. Damaged accessories generally break
during this test period
ENGLISH
RH259 RH253A
6,2/90 6,2/90
360 320
YES YES
0 ÷ 9.500 0 ÷ 11.500
9 3
150 150
- YES
0,800 0,750
8
RH256A RH259A
6,2/90 6,2/90
320 360
YES YES
0 ÷ 10.500 0 ÷ 9.500
6 9
150 150
YES YES
0,750 0,800