Basic Operation; Dvd Setup Menu - SOUNDMASTER PDB1910 Bedienungsanleitung

PDB1910 / English Instruction Manual
INSTALLATION
Use only the supplied power adapter!
Make sure that the mains voltage corresponds to that on the rating label of the AC adapter.
Connect the AC adapter to the right side of the device and to an electrical outlet. The charging
indicator on the device lights up:
LED on: The built-in batterie is charging.
LED off: Built-in batterie is fully loaded
Switch on the device with the ON / OFF switch on the right side.
To prevent accidental discharge of the built-in battery, please slide the on / off switch to the OFF
position when the device is not in use.
ERP power management
The device automatically switches to standby after 30 minutes if no playback takes place.
To turn the device back on, turn the power off and on again.

BASIC OPERATION

SWITCH ON/OFF
Long press the button "
/ SETUP" to switch the unit into standby. The power indicator is off.
Press again the button „ / SETUP" to switch the unit on. The power indicator lights.
SOURCE SELECTION
At the unit:
Press the "MODE" button and select with the " " the desired function. Confirm the
C /
selection with the " OK " button.
With remote control:
Press the "INPUT" button and select the desired function with "
CH- / CH+". Confirm the
selection with "OK".
VOLUME ADJUSTMENT
Press the "VOL –" or "VOL +" button on the remote control or on the unit to decrease or
increase the volume.
MUTE
Press the „MUTE" button on the remote control to switch off the volume.
Press the button again to switch on the volume.

DVD SETUP MENU

In DVD mode, press "SETUP" button to enter the setup menu. Use cursor buttons
to
select the preferred item. After finishing settings, press "SETUP" again to go back to normal
display. The following menu items can be changed:
➢ SYSTEM SETUP
➢ LANGUAGE SETUP
➢ AUDIO SETUP
➢ VIDEO SETUP
➢ DIGITAL SETUP
3