Inhaltsverzeichnis
Werbung
4.4.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the product and also at the end of each
water intake hose where they are connected to the tap. These filters prevent foreign substances and dirt in
the water to enter the product. Filters should be cleaned if they are dirty.
1.
Close the taps.
2.
Remove the nuts of the water intake hoses to access the filters on the water intake valves. Clean them
with an appropriate brush. If the filters are too dirty, remove them from their places with a pliers and
clean in this way.
3.
Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean
thoroughly under running water.
4.
Replace the gaskets and filters carefully and tighten their nuts by hand.
4.4.5 Draining remaining water and cleaning the pump filter
The filter system in your product prevents solid items such as buttons, coins and fabric fibers clogging the
pump impeller during draining of washing water. Thus, the water will be drained without any problem and the
service life of the pump will extend.
If the product fails to drain water inside it, the pump filter is clogged. Filter must be cleaned whenever it is
clogged or in every 3 months. Water must be drained off first to clean the pump filter.
In addition, prior to transporting the product (e.g., when moving to another house) water should be drained
completely.
A
WARNING:
WARNING:
inside the product must be drained when the product is not in use.
WARNING:
In order to clean the dirty filter and drain the water:
1 Unplug the product to cut off the supply power.
A
WARNING:
filter after the water inside the product is cooled down.
30 / EN
Foreign substances left in the pump filter may damage your product or may cause noise problem.
In regions where freezing is possible, the tap must be closed, system hose must be removed and the water
After each use, turn off the tap to which the mains hose is connected.
Temperature of the water inside the product may rise up to 90 ºC. To avoid the risk of scalding, clean the
Washing Machine / User's Manual
Werbung
Inhaltsverzeichnis
