Epson TM-L90P Bedienungsanleitung Seite 9

.
Using Different Paper Widths
The TM-L90 accommodates 80 mm wide paper rolls with no
adjustments. For rolls from 38 mm to 70 mm wide you use the spacer
included with the printer. (If the rolls are from 61 to 70 mm wide, you
break two tabs off the spacer. See the width note below.)
1. Insert the paper roll spacer so that the front edge goes through the
notch and down to the shaft, as shown below.
front edge
2. Push the paper roll spacer until you feel it click onto the shaft.
Note:
Check that the paper roll spacer slides smoothly to the left and right.
shaft
3. Slide the roll paper spacer to the appropriate width, as shown
above. You can use the measurement printed inside the printer,
aligning the inside edge of the spacer with the desired
measurement.
All manuals and user guides at all-guides.com
English
notch
roll paper
spacer
inside edge of
the spacer
TM-L90 User's Manual 7