Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.2 Alarm simulation
Press and hold the TEST button on the smoke detec-
tor to simulate the alarm. As in the case of an alarm,
the LED flashes once per second and an alarm signal
sounds until you release the TEST button again.
7.3 Battery / replacement of the smoke
detector
The operating time of the 3V lithium battery in this
smoke detector is ten years.
When the battery is low, a beep sounds every 40
seconds. The LED continues to flash every 40 seconds.
The low battery indication is given for at least 30
days. Replace the smoke detector with a new device
during this period.
If the smoke detector signals a low battery, you can
interrupt the signal tone for 10 hours by pressing the
TEST button. During this time, the smoke detector
can normally still detect smoke. Make every effort to
replace it with a new unit without delay!
Note
In addition to the life of the battery, the life of
the smoke detector (especially the sensor) is also
limited in time. Therefore, before installing the
smoke detector, observe the date printed on it for
replacement. Replace the smoke detector with a
new unit on this recommended date, even if there
is no indication of a low battery yet.
7.4 Care
Clean the smoke detector regularly (at least once a
month) to remove dust, dirt and debris.
Use a hoover with a soft brush and carefully vacuum
all sides and covers of the smoke detector.
Make sure that the smoke detector does not have
any function-relevant damage (e.g. cracks in the
housing). If this is the case, replace the smoke
detector with a new device.
Ensure that all specifications are met according
to the installation location (see 4. Installation).
In the event of structural/recognisable changes,
check whether the existing installation of the smoke
detector device still meets all relevant requirements.
If necessary, adjust the installation accordingly.
Warning
• Check each smoke detector that you dismantle
(see 7.5. Dismantling the smoke detector)
and reinstall or install in a different place for
its function as described in 7.1. Test!
Warning
• Immediately replace smoke detectors that no
longer function correctly with new devices.
7.5 Dismantling the smoke detector
• If necessary, remove the locking pin to be able to
dismantle the smoke detector.
• Turn the smoke detector counterclockwise to
remove it from the base plate.
• Store the smoke detector in a safe and dust-free
place if it is to be dismantled for a short time,
e.g. during renovation work, or replace it with
a new device.
• Now carry out the assembly and function check
- as described in 5.2. Installing the smoke
detector.
8. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
9. Declaration of performance
The declaration of performance for this product can
be found at:
www.hama.com ->00223842 -> Downloads
10.Manufacturer and approval holder
Siterwell Electronics CO., Limited
No. 666 Qingfeng Road, Jiangbei District, Ningbo,
Zhejiang Province, China
Distributed by
Hama GmbH & Co KG
86652 Monheim / Germany
www.hama.com
18
0786
DoP: GS526G-CPR-001
EN14604:2005 + AC:2008
11
Werbung
Inhaltsverzeichnis
