Husqvarna K 770 Dry Cut Bedienungsanweisung Seite 57

6. Put your right foot on the lower section of the rear
handle to push the product against the ground.
WARNING:
rope around your hand.
7. Pull the starter rope slowly until you feel a resistance
as the starter pawls engage. Then pull continuously
and quickly.
CAUTION:
rope fully and do not let go of the starter
rope handle when the starter rope is
extended. This can cause damage to the
product.
8. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.
To stop the product
WARNING:
continues to rotate up to a minute after
the motor stops (known as blade coasting).
Make sure that the cutting blade can rotate
freely until it completely stops. Carelessness
can cause serious personal injury.
861 - 005 - 22.04.2022
Do not wind the starter
Do not pull the starter
The cutting blade
• Move the STOP switch to the right to stop the
engine.
To use a dust bag
There are 2 types of dust bags for this product:
• Dust bags that you use one time and discard when
they are full.
• Dust bags that you remove the dust from and use
again.
1. Examine the dust equipment. Refer to
the dust equipment on page 51 .
2. Make sure that the dust bag inlet is at a lower
position than the product during operation.
3. Make sure that the dust bag does not tilt. Make sure
that the dust bag inlet is as near the ground as
possible.
To examine
57