Husqvarna K 770 Dry Cut Bedienungsanweisung Seite 53

• Stand at a comfortable distance from the work piece.
• Make sure that the cutting blade can move freely
and are not in contact with anything when the engine
is started.
• Always monitor the product when the engine
operates.
• If the blade is binding in the cut or when aborting
a cut, release the throttle and wait until the blade
stops. Do not extract the blade from the cut while the
blade is in motion otherwise kickback may occur.
• Apply the cutting blade gently with high rotating
speed (full throttle). Maintain full speed until cutting
is complete.
• Let the machine work without forcing or pressing the
blade. If the blade starts to wobble, reduce the feed.
If the blade still wobble, stop cutting and replace the
blade.
• Feed down the machine in line with the blade. Do
not twist in the cut as side pressure can cause
binding in the cutting slot and cause blade damage
or kickback.
861 - 005 - 22.04.2022
• During all cutting operations, make sure that the
blade guard extender and the dust shield are flush
with the work piece.
Push the cutting blade to the full cutting depth at
the top/ front of the cut and move the cutting blade
slowly down/rear. This decreases the temperature of
the cutting blade and helps to collect the dust.
Fuel
This product has a two-stroke engine.
CAUTION:
result in engine damage. Use a mixture of
gasoline and two-stroke oil.
Two-stroke oil
• For best results and performance use HUSQVARNA
two-stroke oil.
• If HUSQVARNA two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION:
oil for water-cooled outboard engines,
also referred to as outboard oil. Do not
use oil for four-stroke engines.
OilGuard
Note:
Applicable only to K 770 Dry Cut installed with
OilGuard (optional) and filled with a mixture of gasoline
and HUSQVARNA two-stroke oil.
• OilGuard is a built-in system that senses an incorrect
fuel mixture.
• When the product operates, a detector reads the fuel
mixture during 10 seconds. If the correct mixture is
used, the product operates at the correct speed. If
the incorrect mixture is used, the product decreases
the engine speed to 3800 rpm to prevent engine
failure.
• To make the product operate at the correct speed,
drain the incorrect fuel mixture. See
and two-stroke oil on page 54 . Fill the product with
the correct fuel mixture.
Incorrect type of fuel can
Do not use two-stroke
To mix gasoline
53