Husqvarna K 770 VAC Bedienungsanweisung Seite 56

5. Install the new drive belt.
6. Make sure that the drive belt is put in correct
position.
7. Install the 2 belt guards.
8. Adjust the tension on the drive belt. See
the tension of the drive belt on page 56 .
To adjust the tension of the drive belt
1. Loosen the 3 nuts.
56
2. Turn the adjuster screw clockwise to increase the
tension of the drive belt.
3. Jiggle the blade guard (A) up and down 3–5 times.
Tighten the nuts (B).
Starter housing
To adjust
To remove the starter housing
1. Loosen the 4 screws on the starter housing.
2. Remove the starter housing.
To replace a damaged starter rope
A
WARNING:
Always be careful and
always use eye protection when you replace
the recoil spring or the starter rope. There is
tension in the recoil spring when it is wound
in the starter housing. The recoil spring can
eject and cause injury.
705 - 003 - 22.04.2022
B