Symbols Used - Bosch Rexroth LU 2/P Montageanleitung

22/42 Assembly
Table 6: Symbols used
1 2
SW13
M = 20Nm
D
SW5
M = 8Nm
D
GHD
Loctite 248
1 2 3
A B C X
Bosch Rexroth AG, MIT: LU 2/P-24V-3L, 3 842 557 976/2020-08

8.4 Symbols used

Connection with T-bolt and fl ange nut.
Make sure the T-bolt is in the correct position when inserting it into the slot and
tightening it. The notch at the head of the screw indicates the orientation of the
T-bolt.
1 = T-bolt insertion position in the slot.
2 = T-bolt clamping position in the slot.
Tightening torque: 25 Nm (M8)
Hex wrench
SW = wrench size ... mm
M = required tightening torque ... Nm
D
Hex socket wrench
SW = wrench size ... mm
M = required tightening torque ... Nm
D
Lubricate/lubricate with specifi c mineral oil:
• GHD: Structovis GHD, www.klueber.com
Seal the G1/8 threads using:
Loctite 248 : medium strength (detachable), www.loctite.de
Graphical depiction of the assembly steps.
The numbers correspond to the sequence of installation steps, in accordance with
the instructions in the accompanying text.
Graphical depiction of the designation of components.
The letters denote the components mentioned in the accompanying text.
Detail view from a diff erent direction,
for example, the back or the bottom side of the product.