Philips PR3092 Bedienungsanleitung Seite 24

ENGLISH
24
The BlueTouch Pain The preset treatment time is
Relief Patch suddenly
switches off during
treatment.
The infrared sensor is blocked.
The skin temperature is too
high.
The BlueTouch Pain The skin temperature is too
Relief Patch switched off high. If the infrared sensor
and the charging light senses a too high temperature,
the BlueTouch Pain Relief Patch
switches off.
The charging light turns The rechargeable batteries are
solid red for 5 seconds, empty.
the BlueTouch Pain
Relief Patch beeps and
it is not possible to
select a mode.
The charging light is The batteries contain just
solid orange. enough energy for one
treatment.
The adapter becomes This is normal.
warm during charging.
The charging light does The adapter is not inserted or
not inserted properly into the
when the micro USB wall socket.
plug is inserted into the
micro USB socket on
the connection panel.
The standard USB plug is
not inserted or not inserted
properly into the adapter.
The wall socket into which the
adapter is not live.
Solution
The BlueTouch Pain Relief Patch has been
programmed to switch off automatically
after the treatment time in the selected
treatment mode has elapsed.
Check the position of the patch in the
strap. Make sure the strap does not cover
the infrared sensor. If the infrared sensor is
not covered but the BlueTouch Pain Relief
Patch still switches off, it is probably broken.
In that case, contact Philips.
Check if you do not wear too many or too
thick clothes over the BlueTouch Pain Relief
Patch during treatment.
Let the BlueTouch Pain Relief Patch cool
down for 10 minutes. After 10 minutes, the
LEDs go on in power-save mode. Put the
BlueTouch Pain Relief Patch back on your
skin and continue your treatment.
Charge the BlueTouch Pain Relief Patch
(see chapter 'Charging').
Complete the treatment and charge
BlueTouch Pain Relief Patch after use
(see chapter 'Charging').
No action required.
Insert the adapter into the wall socket
properly.
Insert the standard USB plug into the
adapter properly.
Connect another appliance to the same
socket to check if the socket is live. If the wall
socket is live, but the BlueTouch Pain Relief
Patch does not charge, contact Philips.