Philips PR3092 Bedienungsanleitung Seite 21

Possible reactions and side-effects
- It is normal for the skin to become a little red during treatment.
This skin redness is caused by increased blood circulation due to
the warmth of the BlueTouch Pain Relief Patch. This skin redness is
harmless and fades after the treatment has ended.
- In some cases tanning may be visible after treatment. This tanning is
caused by melanin concentrations in the skin and is a similar effect
to that caused by exposure to sunlight. It is harmless and fades away
within 48 to 72 hours. Postpone treatment until the tanning has
disappeared. To prevent tanning, resume treatment in a lower mode
and avoid excessive pressure on the BlueTouch Pain Relief Patch during
treatment, for example by sitting or lying on it or by leaning heavily
against it.
Light and sound signals during use
Overheating signal
1
2
3
timer starts counting down where it stopped.
Note: If treatment is not resumed within 2 hours, the timer is automatically
reset.
Resetting signal
When the software of the BlueTouch Pain Relief Patch no longer responds
or another unexpected failure occurs, you can reset the BlueTouch Pain
Relief Patch.
1
adapter or connect it to a USB port of a computer.
2
,
,
normally again.
Battery level signals
When you press the mode button, the charging light shows the battery
status. The charging light goes out when the sensor senses skin contact or
when the device is switched off.
ENGLISH
21