Setting Up; Preparing The Remote Control; Setting Up The Remote- Controlled Socket - Silvercrest 284705 Bedienungs- Und Sicherheitshinweise

all times if such an event occurs.
In the event of a leakage of batteries /
rechargeable batteries, immediately
remove them from the product to
prevent damage.
Only use the same type of batteries /
rechargeable batteries. Do not mix
used and new batteries / recharge-
able batteries.
Remove batteries / rechargeable
batteries if the product will not be
used for a longer period.
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.

Setting up

Q
P reparing the remote
Q
control (fig. A)
CAUTION! Danger of explosion in
the case of improper battery re-
placement. Only replace with the
same or equivalent battery type.
1. Open the battery compartment on
the back of the remote control by
284705_silv_Funksteckdosen-Set_IP20_Content_CZ_SK.indd 9
Safety / Setting up
turning the battery compartment
cover 4 anti-clockwise with the
aid of a coin or a screwdriver, then
removing the lid (open).
2. Insert the round cell battery type
CR 2032. Make sure you fit the
battery with the correct polarity
(+ = up).
3. Place the battery compartment cov-
er 4 back on and lock it in place
by turning it in a clockwise direc-
tion (close).
4. Press one of the ON / OFF buttons
2 or 3 to test whether the remote
control works; if it does, the power
indicator light will come on 1 .
S etting up the remote-
Q
controlled socket
1. Plug the remote-controlled socket
into an earthed household socket.
2. The LED operating status display
will now flash slowly for approx.
30 seconds after plugging in.
3. Aim the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
4. With the LED operating status dis-
play flashing, press the desired
5
ON button of the channel ON /
OFF button (A, B, C or D) on
2
the remote control. The LED operat-
ing status display
continuously. You can now use the
remote control to switch a connect-
ed device on or off using.
5. Repeat this process with the other
wireless sockets.
5
will now light
5
GB 9
21.06.17 15:35