Connecting The Power Supply; Technical Specifications - Siemens SIMATIC IFP1500 ETH Produktinformation

Connecting the power supply

The specifications in the operating instructions "SIMATIC HMI Industrial Flat Panels IFP, IFP PRO, IFP ETH" apply. Refer to
the section "Connecting a DC power supply" for information on connecting the power supply.
You can operate the device with the following voltage:
● 24 V DC, 2-pin
Note
The device does not have an on/off switch. To turn off the device completely, disconnect it from the power supply.
Securing the cables
Use cable ties to secure the connected cables to the selected fixing elements for strain relief. Make sure that the cables are
not crushed by the cable tie.
Commissioning on a PC with Skylake CPU
Note: Advanced commissioning on a PC with Skylake CPU required
Advanced commissioning of the Ethernet monitors is performed in conjunction with PCs equipped with a Skylake CPU. For
advanced commissioning on a PC with Skylake CPU follow the description in the following Product Information:
Commissioning on the SIMATIC IPC427E/IPC547G or PC with Skylake CPU
(https://support.industry.siemens.com/cs/de/en/view/109749188)

Technical specifications

Certificates and approvals, ErP Directive
Approvals
Note
Only the approvals specified on the rear of the device are valid for the device. A description can be found in the underlying
operating instructions.
In addition, the device meets the requirements of the following directive:
● ErP Directive (EU) 2019/2021 "Commission Regulation laying down ecodesign requirements for electronic displays
pursuant to Directive 2009/125/EC of the European Parliament and of the Council, amending Commission Regulation
(EC) No 1275/2008 and repealing Commission Regulation (EC) No 642/2009"
12
SIMATIC IFP1500/1900/2200 ETH
A5E41610279-AE, 10/2021