Troubleshooting - AEG JP 10 Originalbetriebsanleitung

34 www.aeg-automotive.com
Using the 12 V car socket
1. Press the „12V" button (1) to switch on the
12 V car socket (12).
2. Connect the plug of an external device to the
12 V car socket (12).
3. After using the external device, disconnect the
12 V car plug from the 12 V car socket.
4. Press the „12V" button (1) again to switch off the
12 V car socket (12).

TROuBLEShOOTInG

Problem
Device isn't working.
Low voltage alarm is always on.
Using the 2.0 USB output socket
1. Press the
2. Plug an external USB device into the USB
The uSB port delivers 5 V of direct current for
external USB devices (e.g. lamps, fans, radios).
note:
•
•
3. Press the
Possible cause
Battery pack defective or drained.
The power draw of the connected
device is too high.
Device operation was interrupted
by one of the safety systems.
The fuse has blown.
Voltage or power are not suffici-
ent to power the inverter.
button (2) to switch on the USB
port (8).
port (8).
The uSB port is not intended for data transfer.
Do not connect memory sticks, MP3 player or
similar data storage external appliances.
button (2) again to switch off the
USB port (8).
Solution
Replace or charge the battery pack.
Disconnect the external device.
The maximum power draw should not exceed
the power rating of the voltage converter.
See the relevant chapter ( Technical Features).
Replace the fuse (see chapter „Replacing
fuses").
Check connections and verify whether is a pro-
blem caused by cables (not clean or damaged)
or the clips.