General Inspection; Lubrication; Battery Disposal; Maintenance And Cleaning - Westfalia ARW 18 Originalanleitung

General Inspection

 Regularly check that all the fixing screws are tight as they may
become loosened during use due to vibration.
 Inspect the supply cord of the charger for damage or wear prior to
each use. Repairs should be carried out by an authorised service
centre. This advice also applies to extension cords used with this
tool.

Lubrication

 Slightly lubricate all moving parts at regular intervals with a suitable
spray lubricant.

Battery Disposal

1. Run motor until the battery is completely discharged.
2. Remove the battery from the tool.
3. Wrap heavy insulating tape around the battery terminals or enclose
in a sealable plastic bag to prevent possible shorting.
4. Dispose of the battery through your local waste removal authority.

Maintenance and Cleaning

 Remove the battery before undertaking any cleaning or maintenance
work.

Clean the flexible shaft with warm water and some detergent and
allow it to fully dry in extended condition. After drying lightly oil the
flexible shaft.
 Use only a moist cloth to clean the unit. Do not use aggressive
chemicals which may dissolve plastic parts, or abrasives. Always
keep the ventilation slots clean and free from obstructions.
 The drain auger is maintenance-free.
 The battery can be recharged up to 500 times if treated carefully.
However, over time the battery's performance can deteriorate. If
necessary you can purchase a 2.0 Ah replacement battery under the
article number 87 84 74 and a 4.0 Ah replacement battery under the
article number 87 84 75 from Westfalia.
Operation
24