The Worklight; Driving Forward And Retracting The Flexible Shaft And Setting The Rotating Direction - Westfalia ARW 18 Originalanleitung

 Ensure that the charger is disconnected from the mains supply after
use, and is stored correctly.
 Do not leave batteries on charge for extended periods and never
store batteries on charge.
 The battery charger monitors battery temperature and voltage while
charging. Remove the battery once charging has been completed to
maximise charge cycles of the battery and not waste power.
 Batteries can become faulty over time, individual cells in the battery
can fail and the battery could short. The charger will not charge
faulty batteries. Use another battery, if possible, to check correct
functionality of the charger and purchase a replacement battery if a
faulty battery is indicated.
 Do not store Lithium-Ion battery packs in a discharged state long
term. This can damage the Lithium-Ion cells. For long-term storage,
store batteries in a high charge state disconnected from the power
tool.
 The capacity of batteries will reduce over time. After 100 charge
cycles, the battery's operation time and the maximum torque per-
formance of the tool will slightly reduce. This decline will continue
until the battery has minimal capacity after 500 charge cycles. This
is normal and not a fault with the battery pack.
Operation

The Worklight

When the trigger switch (4) is pressed the work light (7) turn son. When
the trigger switch is released the work light turns off after approximately
five seconds.
Driving forward and retracting the flexible Shaft and setting the
rotating Direction
The machine is equipped with two operating elements, a for-
ward/neutral/reverse lever and a rotating direction switch.
To unblock a drain use the machine in clockwise rotation. To do so set
the rotating direction switch (3) so that the end left end marked with R
is proud of the machine. When the machine is started with the trigger
Operation
22