Bosch Rexroth IndraControl VCP05.2 Projektierungsbeschreibung Seite 33

Bedienoberfläche Schweissen / Resistance welding user interface VCP05.2 | R911172348 Bosch Rexroth AG
3. Choose Update
4. Choose Copy USB Stick
5. Choose Copy to USB with
6. Confirm with ok
The data inclusive the file HMI.Config.XML will be saved on
the USB-stick in the path ..\Backup\TSvisRT\ . After the
copying is ready, confirm with ok .
7. Unplug the USB-stick, plug it into notebook and open the file
HMI.Config.XML.
In this file enter the connections with IP addresses and names
and store it. Here an example of
2 connections:
<?xml version="1.0" encoding="utf-8" ?>
<ROOT>
<ConnectionList>
<Connection Number="*" IPAddress="0.0.0.0"
Name="n/v"/>
<Connection Number="1"
IPAddress="10.110.220.118" Name="SST1"/>
<Connection Number="2"
IPAddress="10.110.220.119" Name="SST2"/>
</ConnectionList>
</ROOT>
The names may not be chosen longer than 6 signs, the rest is
not represented later. There are up to maximally 16
connections possible.
The construction of this file may not be changed to the
extension of the connections with copying / insert. The alterable
values are represented in italics.
8. Plug the USB-stick again to VCP and choose Copy to Flash.
For this use cursors.
9. Choose the path with Cursors up and down, then Backup and
confirm.
10. The data are written to the VCP with Start.
11. After this choose Home, Home and with Exit leave the menu.
Now the VCP is booting and the settings are finish.
12.
33/38
Ethernet Communication
and