Bosch Rexroth IndraControl VCP05.2 Projektierungsbeschreibung Seite 30

30/38 Bosch Rexroth AG | Bedienoberfläche Schweissen / Resistance welding user interface VCP05.2 | R911172348
Operation
F6-F1
Timer data
F6-F2
Timer start inhibit/ignition
F6-F3
VCP data 1
VCP data 2
F6-F4
Timer time
F6-F5
Language change-
over/contrast
F6-F6
I/O
IP address
Gateway
Timer type and firmware version
Timer name (BOS)
Start inhibit program specific and
global
Weld internal program specific and
global
Transformer transmission
VCP project name
date, time
IP address VCP
Ident., serial number
Interface
Firmware version
Time / date VCP
max. prog.
max. electrode number
max. time
max. weld time
max. %I
Time / date of timer
Language of user interface
Display contrast VCP
Status of I/Os internal and external:
overview
Notes:
(1) Navigation in Weld sequence and VCP data using.
(2) Weld sequence Quick-mode and Monitoring Quick-mode display the same
parameters as Weld sequence 1 – 5 and Monitoring 1 – 3 in compact form.
The parameters are designated with their abbreviations (see third column above).
(3) Navigation in the Prewarning table, Error log and Weld fault log:
Up/down using [F5] and [F6], left/right using
(4) Set Change electrode in the Set counter menu using [F6]
(5) Information on the Extension menu – specific to the respective timer,
refer to timer documentation.
Data release
(6) First press the
number with and
keys
. Then switch with the cursor key
on
keys the setting to
Then switch with the cursor key
On/Off
Change with the
With the cursor key you can switch to the
parameters in the same way.
key . Then you can select the program
keys or insert the program number with the
On/Off
to and change with
off
or .
to the global setting
and keys.
Weld on
display
Set
(6)
on/off
enter
display
display
select
set
(7)
display
editing
and
(S) .
parameters and set the