Finish Operation; Care And Maintenance - Kärcher AF 100 Originalbetriebsanleitung

Change filter indicator
If the filter change indicator lights up:
see care and service.
Note
– The filter change indicator flashes at 2x per second
if the filter remaining run time is less than 72 hours.
– The filter change indicator lights up continuously
when the end of the filter service life is reached.
The appliance continues to work.
– In areas with predominantly high humidity (> 60%),
there may be odour generation on the filter. In such
cases, we recommend replacing the filters sooner.

Finish operation

 Press the on/off operation button to switch the de-
vice off.
Storing the appliance
 Store the appliance in a dry room.

Care and maintenance

 First remove the mains plug before doing any job
on the device
 Wipe off the device with a dry soft cloth.
 If necessary, clean the pre-filter.
Filter replacement
If the filter change indicator lights up:
Illustration
 Open and remove the filter covers with the handles.
 Clean the pre-filter when installed (e.g. with a vac-
uum cleaner or suction brush).
 Unlock and then remove the pre-filter.
 Remove the main filter at the grab tab from the device.
Note
– Both pre-filters always have to be cleaned.
– The pre-filter is washable.
– Both main filters always have to be renewed.
Illustration
 Take the main filter out of the packaging.
 Fit the main filter into the device. The grab tab
should be visible from the outside.
 Insert the guide noses of the pre-filter in the lower
recesses.
 Carefully lock the pre-filter at the top and at the
sides.
 Insert the guide noses of the filter cover in the lower
recesses.
 Close the filter cover from above.
Reset filter change indicator
 To reset the filter change indicator to 100% filter
lifespan after a filter change, the filter change indi-
cator button must be pressed for 5 seconds in
standby mode.
Note
– The filter change indicator button does not light up
until the end of the calculated filter service life has
been reached. To reset the filter runtime to 100% in
advance, the filter change indicator button must be
pressed for 5 seconds.
– Since the position of the unlit button is difficult to
see, the position can be made visible by unplug-
ging and plugging in the mains plug. The button
lights up briefly so that you can remember the po-
sition.
Troubleshooting
Appliance is not running
 Plug in the power cord.
 Close the filter cover.
 Should the error continue to exist:
Do not press the on/off operation button again.
Contact customer service.
Air quality does not improve
 Make sure that all filters have been inserted cor-
rectly.
Airflow from the air outlet is no longer so
 Clean pre-filter.
– 7
EN
strong
11