Bosch Rexroth 2GE Serie Montageanleitung Seite 50

50/70 Bosch Rexroth AG
Safety Instructions
DANGER
Dangerous movements!
Danger to life, risk of serious injury or damage to equipment!

Ensure personal safety, either by means of monitoring devices or by superior measures
directly on the system.

The measures depend on the specific system conditions and are determined based on
a risk and error analysis. The safety regulations applicable to the system must be taken
into consideration. Unintended machine movements or other malfunctions may occur
when the safety equipment is switched off, bypassed, or not activated.

Do not enter the machine's and machine parts' range of movement. Possible measures
to prevent unauthorized entry of persons include e.g. protective barriers, protective en-
closures, protective cover or photocells.

Barriers and covers must be rigid enough to withstand the maximum possible momen-
tum.

The emergency OFF switch must be easily accessible within immediate vicinity. Check
the function of the emergency OFF system before commissioning. If the emergency
OFF switch malfunctions, do not operate the device.

Protection against unintended start-up by means of an emergency OFF circuit.

Safely bring the drives to a standstill before accessing or entering the danger zone.

Additionally secure vertical axes from falling or dropping after the motor is switched off
by mechanical locking of the vertical axis, external braking/catching/clamping devices
and sufficient weight compensation of the axis.

Switch electrical equipment to a de-energized state at the mains and protect it against
unintentional switch-on during: Maintenance and repair works, cleaning and long dis-
ruptions in operation.

Avoid operating high-frequency, remote-controlled, or radio devices in the vicinity of
the device electronics and cables. If this cannot be avoided, check the device and the
system for malfunctions in all working positions. In some cases, a special EMC inspec-
tion of the entire system may be necessary.

Use a torque support if tightenings with higher torques are to be performed with a
hand-held tightening spindle.
2/3/4/5GE.... | 3 608 870 E96/2016-03