Commissioning; Operation - Bosch Rexroth EC302 Montageanleitung

EC30X | 3 609 929 728/2014-01
7

Commissioning

CAUTION
Use of wrong components!
Damage to persons and property!

Only operate the tightening spindle
in connection with the intended com-
ponents!
CAUTION
Loss of protection class IP 54 due to
missing seals and plugs!
Liquids and foreign bodies may penet-
rate and damage the product.

Ensure before the commissioning
that all caps have been mounted.
The tightening system is commissioned by
the operating system, e.g. BS350.
Notes on the commissioning can be
found in the software of the Rexroth
tightening system, i.e. the operating
system, e.g. BS350.
The electronic connection between the
measurement transducer and the servomo-
tor is established using the measurement
transducer connecting cable.
The electronic connection between the ser-
vomotor and the tightening system is estab-
lished using the connecting cable tigh-
tening spindle.
Bosch Rexroth AG
8

Operation

CAUTION
Hot surfaces possible on motor
housings and gearboxes!
Risk of injury! Risk of burns!

Do not touch device housing surfa-
ces at heat sources! Risk of burns!

Do not touch housing surfaces of
motors and gearboxes! Risk of burns!

Depending on the operating condi-
tions, temperatures during or after
operation may exceed 60 °C
(140 °F).

After switching off the motors, allow
them to cool down sufficiently before
accessing them.

Wear protective gloves or do not
work near hot surfaces.

For specific applications, the manu-
facturer must undertake measures on
the end product, the machine, or the
system to prevent burn injuries du-
ring the end use. These measures
must be in accordance with the saf-
ety regulations. Examples of possible
measures are: safety warnings, a se-
parating safety device (shielding or
locking), and technical documenta-
tion.
55/72