Inhaltsverzeichnis
Werbung
Dust Removal
The jigsaw can be connected with a dust removal or a vacuum cleaner via a
suction pipe (5). The suction shows the best results when the plastic cap is put
on (3). Always use a dust removal, if possible, or at least a dust mask for your
own safety.
Guide Bar
Use the bar delivered (1) for a cutting guide parallel to a wood edge. Insert the
marks for adjustment on the base plate. Look about the left mark if the bar is
on the right side and vice versa (see left picture). You can fix the bar in the
desired position with the 3 mm hexagonal wrench.
Maintenance and Cleaning
While cleaning, always disconnect the unit from the power supply.
After every use clean the unit of wood dusts with a hand brush or a cloth. You
must particularly clean regularly the air exhaust of the engine. The engine can
overheat if the exhausts are closed.
Maintenance and repair work can only done by a qualified technician. You can
also contact the Westfalia Service.
Initiation
bar from left or right through the
two openings in the base plate.
You
between bar hanger and saw
blade by using the centimetre
scale on the bar. There are two
7
can
adjust
the
distance
Werbung
Inhaltsverzeichnis
