Inserting The Tools; Switch On/Off - Westfalia M1Q-06-80T Bedienungsanleitung

Inserting a Tool
Before inserting a saw blade the plastic cap
of the tool retainer must be removed. Proceed
here as shown on the photo. Disperse slightly
the rear and then push the cap forward.
First loosen the socket screws in the tool
retainer (7) before inserting the saw blade.
For that, you can use the hexagonal wrench
delivered (12). Then insert the saw blade into
the retainer as far as it will go. There is a
wheel with a circulating socket below the retainer (8). Make sure that the saw
blade is in this socket after installation.
Please note: The saw blade will be very hot after cutting due to friction. Pay
attention for that when removing the saw blade. Protect yourself with
protective gloves if necessary.
Start-Up
Please note the power supply voltage. Make sure that the voltage on the name plate of
the power supply complies with the power supply voltage of your power source. Units
marked with 230V can be operated with 220V - 240V.
Turning On/Off
Slide the push button (1) forward until it will engage to turn on the saw. Press
slightly on the rear of the button and it will return in turn-off-position.
Wood dusts can be harmful to your health. Wear a dust mask
while working. Read the safety notes attached for your own
safety.
Initiation
5