Operation Description - Siemens SITRANS LR200 Kurzanleitung

1.4. Units
Sensor measurement units.
Options
1.5. Operating Mode
space
level
Operation Description
NO Measurement and associated loop current are not
SERVICE updated, and the device defaults to Fail-safe mode
LEVEL Distance to material surface
SPACE Distance to material surface
DISTANCE Distance to material surface
a)
For more details on Fail-safe Mode refer to the full manual.
1.6. Low Calibration Point
Distance from sensor reference point to Low Calibration Point: usually process empty level.
Range: 0.00 to 20.00 m
Values
1.7. High Calibration Point
Distance from sensor reference point to High Calibration Point: usually process full level.
Range: 0.00 to 20.00 m
Values
1.8. Apply? (Apply changes)
In order to save the Quick Start settings it is necessary to select Yes to apply changes.
Options
Press Mode to return to Measurement mode. SITRANS LR200 is now ready to operate.
A5E31993614
M, CM, MM, FT, IN
distance
high cal.
point
YES, NO, DONE (Display shows DONE when Quick Start is successfully
completed.)
SITRANS LR200 (HART) – QUICK START MANUAL
sensor
reference
point
low cal.
point
Reference point
a)
.
Low Calibration Point
High Calibration Point
Sensor reference point
Page EN-17