Preparing The Ocr And Votingdisk For Clusterware On Windows 2008 - Dell PowerVault MD3000i Bedienungsanleitung

Click Finish.
g
Repeat step a through step g to create an additional OCR disk.
h
10 Create a logical drive for the Voting Disk.
On the partition area of the disk identified for the OCR and voting
a
disk (2 GB LUN/virtual disk), right-click the free space and select
New Logical Drive.
The Welcome to the New Partition wizard is displayed.
Click Next.
b
In the Select Partition Type window, select Logical drive and click
c
Next.
In the Specify Partition Size window, in the Partition size in MB field,
d
type 50 and click Next.
In the Assign Drive Letter or Path window, select Do not assign a
e
drive letter or drive path and click Next.
In the Format Partition window, select Do not format this partition
f
and click Next.
Click Finish.
g
Repeat step a to step g to create two additional voting disk partitions.
h
NOTE:
If you are using Redundant Voting Disk and OCR, repeat the steps outlined
in step 9 and step 10 for the redundant Voting Disk and OCR.

Preparing the OCR and Votingdisk for Clusterware on Windows 2008

NOTE:
The steps to create extended partitions and to create logical drives are
identical to the steps of Windows 2003, however, it is no longer possible to perform
these steps in Windows 2008 from the Disk Management GUI.
The procedure to create extended partitions and logical drives is as follows:
1 Start→ Run and type cmd and click Enter to open a command prompt
window.
2 Type diskpart in the command prompt to open the diskpart interface.
3 Enter list disk and a table is displayed as shown:
Configuring Network and Storage for Oracle RAC Database
45