Preparing The Disks For Oracle Clusterware, Database, And Backup; Enabling The Automount Option For The Shared Disks - Dell PowerVault MD3000i Bedienungsanleitung

Preparing the Disks for Oracle Clusterware,
Database, and Backup
This section provides information for creating the logical drives for the
following disks:
• Oracle Cluster Registry disk (OCR) — Contains the cluster configuration
information
• Voting disk — Provides arbitration between the cluster nodes when the
private network or attached storage is unavailable to one or more nodes
• Data and backup disks — Provide storage areas for creating the database
(data disk) and saving the backup and log data (backup disk)
During the cluster configuration described in this document, you will create
partitions on your shared storage. When you create the partitions, ensure that
the cluster nodes can detect the LUNs or logical disks that are created in the
attached storage system.
To prepare the disks for Oracle Clusterware, identify the OCR, voting, data
and flash recovery area disks. After you identify the appropriate disks, perform
the following steps on node 1:

Enabling the Automount Option for the Shared Disks

1 On node 1, click Start and select Run.
2 In the Run field, type cmd and click OK.
3 At the command prompt, type diskpart and press <Enter>.
4 At the DISKPART command prompt, type automount enable
and press <Enter>.
The following message is displayed: Automatic mounting of new volumes
enabled.
5 At the DISKPART command prompt, type exit and press <Enter>.
6 Close the command prompt.
7 Repeat step 1 to step 6 on each of the remaining nodes.
Configuring Network and Storage for Oracle RAC Database
43