Specifications - Bosch CR 10 H Bedienungsanleitung

Specifications

Dimensions (W × H × D)
Rated voltage
Rated current
BUS interface
Control range
Permitted ambient temperature
Protection class
Protection
Product data for energy consumption
The following product data complies with the requirements of EU Regulation 811/
2013 as a supplement to Directive 2010/30/EU. The class of temperature controller
is required to calculate the central heating energy efficiency of an integrated system,
and it is therefore incorporated into the system data sheet.
Function of CR 10 H
Room temperature-dependent, modulating
1) Classification in accordance with EU Regulation No. 811/2013 for
identification of integrated systems
2) Contribution to seasonal energy efficiency of central heating in %
2.1 Function as room temperature-dependent controller (CO)
The CR 10 H controls the heat source via the room temperature. Only allowed with
timer in Germany. The user interface is not suitable for controlling heat sources from
other manufacturers.
Output control
The heat output of the heat source changes according to the deviation between the
current and required room temperature. This method of control is suitable for a
uniform temperature level, e.g. open-plan house. There are fewer burner starts and
shorter pump runtimes. This control mode may not be available depending on the
heat source that is connected.
CR 10 H – 6720876740 (2017/08)
82 x 82 x 23 mm
8 ... 16 V DC
4 mA
EMS 2 (2-wire BUS)
5 ... 30 °C
0 ... 60 °C
III
IP20
Class
V
Product Information
1) 1),2)
[%]
3.0
19