Klarstein 10030930 Bedienungsanleitung Seite 28

Connecting the water and electricity supplies
Connection to the water and electricity supplies should only be performed by a qualified technician. The dish-
washer should not stand on top of the water hoses or the electricity supply cable The appliance must be con-
nected to the water supply network using new piping. Do not use old piping.
• Connecting the water inlet hose
Connect the cold water supply hose to a threaded 3/4(inch) con-
nector and make sure that it is fastened tightly in place. If the water
pipes are new or have not been used for an extended period of
time, let the water run to make sure that the water is clear and free
of impurities. If this precaution is not taken, there is a risk that the
water inlet can get blocked and the appliance could be damaged.
• Connecting the water outlet hose
Fit the drainage hose of your machine to the drainage pipe without
bending. If the length of the hose is not sufficient, apply to the
authorized service for an extension made from the same material
as the original. Remember that the length of the hose should not
exceed 4meters even when with an extension. If the drainage hose
is longer the 4 m. the dishes will not be cleaned properly secure
your hose firmly to the drainage pipe to avoid it coming off during
the washing process.
Electrical connection
Before inserting the plug into the electrical socket, make sure that the socket is earthed and complies with cur-
rent regulations. The household electrical supply system should be provided and should meet requirements of
the appliance under normal load. The socket must be compatible with the plug of the appliance. If this is not
the case, ask an authorised technician to replace the plug.
Advice regarding the first wash cycle
After the appliance has been installed, immediately before running the first wash cycle, completely fill the salt
dispenser with and add approximately 2 Kg of salt (see Rinse aid and refined salt). The water may overflow: this
is normal and is not a cause for concern. It is also normal that the LOW SALT indicator light continues to flash
for a few cycles after the salt has been loaded.
How to drain excess water from hoses
If the sink is 1000 mm higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or a suitable
container that is held outside and lower than the sink.
Extension hose
If you need a drain hose extension, observe to use a similar drain hose. It must be no longer than 4 metres;
otherwise the cleaning effect of the dishwasher could be reduced.
28