Installation - Westfalia WT 483 Bedienungsanleitung

A3: Radio frequency / volume line bars
A5: Radio ON icon
B – Top view
B1: ALARM 2 SET / ON-Off button
B3: SLEEP button
B5: MEMORY / PRESET button
B7: RADIO button
C – Back view
C1: Mobile devices (not applicable for tablet / iPad)
C3: Backup battery (1 x CR2032, not included)
C5: 5V – 1200mA AC/DC adapter
Please read these instructions carefully and keep the manual for future reference.

INSTALLATION

Plug in the AC/DC adaptor to an AC household outlet, and then plug the DC jack to the back of the
unit. Your unit is ready to work.
BACKUP BATTERY INSTALLATION
Your clock radio requires one CR2032 lithium battery (not included) to provide backup power to the
clock in the event of a temporary power interruption.
1. Place your unit face down on a flat and soft surface.
2. Use screw driver to open the backup battery compartment door located on the bottom of the
unit.
3. Slide and remove the battery cover at the bottom of your unit.
Insert one new CR2032 lithium battery into the battery compartment with the "+" side facing up
4.
as indicated.
5. Close the battery compartment door and tighten the battery door screw.
If AC power is interrupted and backup batteries are being used, the time and all settings of your unit
will be kept. The display backlight is off and alarm does not sound.
SET TIME, 12/24-HR TIME, CALENDAR AND SNOOZE DURATION
1. Press and hold SET, the hour digits flash. Rotate the VOL / TUNING knob to set hour.
2. Press VOL/TUNING knob once again, rotate the VOL/TUNING knob to set minute.
3. Press VOL/TUNING knob once again: 24Hr flash, rotate the VOL/TUNING knob to select
12Hr  24Hr. In 12Hr mode, PM will appear on the display to indicate afternoon time. There
is no AM indicator.
Press VOL/TUNING knob once again, "2018" flash, rotate the VOL/TUNING knob to set the
4.
year.
5. Press VOL/TUNING knob once again, month digits flash, rotate the VOL/TUNING knob to set
the month.
6. Press VOL/TUNING knob once again, date digits flash, rotate the VOL/TUNING knob to set
the date.
Press VOL/TUNING knob once again, "N05" flash, rotate the VOL/TUNING knob to set the
7.
snooze duration (from 5 to 60 min.).
8. Press VOL/TUNING knob again to confirm. The set time is displayed.
Note: the clock exits the set mode when no key is pressed in approximate 10 seconds.
A4: SLEEP icon
A6: + TUNING - / + Volume – (adjust / confirm
knob)
B2: SET button
B4: ALARM 1 SET / ON-Off button
B6: SNOOZE / HI-LO-OFF BRIGHTNESS
button
C2: USB charging cable (not included)
C4: Insert DC jack to power up your unit
EN2