Westfalia WT 483 Bedienungsanleitung Seite 11

ACTIVATE THE SNOOZE FUNCTION (default snooze duration is 5 minutes)
When alarm is sounding, press
after the set snooze duration.
Note: if your second alarm activates while the first alarm is sounding or it is in the snooze mode, the
second alarm overrides the first alarm (the first alarm is reset to come on the next day).
SET UP THE FM ANTENNA
Extend the FM wire antenna fully and vary the direction for best FM reception. Do not strip, alter or
attach to other antennas.
LISTEN TO THE FM RADIO
Press RADIO once to FM tuner mode, the display shows "rd".
1.
2. Press VOL/TUNING knob once, the radio frequency is displayed. You can rotate the
VOL/TUNING knob slowly to tune to a FM radio or rotate quickly to scan the next radio
station automatically. The line bars indicate corresponding radio frequency.
Press VOL/TUNING knob once, the volume level "L04" is displayed. Rotate the
3.
VOL/TUNING knob to adjust volume from L00 (sound off) to L15 (maximum). The line bars
indicate the corresponding volume level.
4. The clock radio will switch to time display in few seconds. Rotate the VOL/TUNING knob to
adjust the volume.
5. Press RADIO button to turn off the radio.
Remark: keep your radio away from fluorescent lamps or other electronic devices, which may cause
interference to the radio.
STORE FM RADIO STATIONS IN MEMORY
You can store up to 20 FM radio stations.
Store radio stations automatically
Press RADIO once to turn on the radio, then press and hold the VOL/TUNING knob, the clock radio
will scan from 87.5 to 108 MHz frequency range once and automatically store radio stations of
strongest signal from "P01" up to maximum "P20".
Store radio stations manually
1. Tune to a FM radio station.
Press and hold MEM for 2 seconds, "P01" flashes. Press VOL/TUNING knob once to
2.
confirm and store to P01.
3. Press VOL/TUNING knob once, the radio frequency is displayed. Rotate VOL/TUNING
knob to select another station.
Press and hold MEM until "P01" (or last memory station) flashes. Rotate VOL/TUNING
4.
knob slowly to select "P02", press VOL/TUNING knob once to store P02.
5. Repeat Step 1 to 3 to store radio stations to P03 through P20.
6. To remove a pre-stored station, repeat steps 2 to 4 to store another station in its place.
SELECT A PRESET RADIO STATION
When the radio is on, press the MEM once. Rotate VOL/TUNING knob to select a preset station.
SET SLEEP TIMER
While the radio is on, press and hold SLEEP, the sleep time "05" (5 minutes) appears on the
1.
display.
2. Press SLEEP repeatedly to select a period (in minutes) from 05, 15, 30, 45, 60, 90, or OFF.
3. The clock radio reverts to time display automatically in a few seconds. Press and hold SLEEP
button to see the sleep time remaining.
once, the alarm will be silenced and come on again
EN4