Siemens Sitrans LR460 Kurzanleitung Seite 14

Configuring a new device
1. Set Address (default for PROFIBUS PA is 126; for HART is 0).
• Point the handheld programmer at the display then press Mode
PROGRAM mode, menu item 1.
• Press Down ARROW
Address (menu item 2.1.2).
• Press Right ARROW
• If required, key in a new value and press Right ARROW
displays the new value and the PROGRAM icon disappears.
2. You will need the most up-to-date Device Description (DD) for your instrument. Launch
SIMATIC PDM – Manager Device Catalog, browse to the unzipped DD file and select it.
3. Launch SIMATIC Manager and create a new project for LR 460. Application Guides for
setting up HART and PROFIBUS PA devices with SIMATIC PDM.can be downloaded from
the product page of our website at:
https://pia.khe.siemens.com/index.asp?Nr=14655
4. Open the Menu Device – Master Reset and perform a Factory Reset.
5. Upload parameters to the PC/PG.
6. Calibrate the device via the Quick Start Wizard.
Quick Start Wizard steps
Notes:
• The Quick Start settings are not independent parameters. The settings are inter-
related, and changes only apply when you click Transfer at the end of step 4.
• Do not use the Quick Start Wizard to modify individual parameters. See the full
manual for detailed instructions.
Open the menu Device – Quick Start, and follow steps 1 to 4.
Step 1 – Identification
Click NEXT to accept default values. (Description, Message, and Last config fields can be left
blank.)
Page EN-12
, Right ARROW
to open Edit mode: the PROGRAM icon
Quick
Start
SITRANS LR 460 – QUICK START MANUAL
, Right ARROW to navigate to
to accept it. The LCD
to activate
will flash.
7ML19985QW81