Power Supply; Mains Operation; Inserting The Back-Up Battery; Environmental Note - Grundig Sonoclock 795 DCF Bedienungsanleitung

POWER SUPPLY

Mains operation

Check that the mains voltage on
the type plate (on the bottom of the
device) corresponds to your local
mains supply. If this is not the case,
contact your specialist dealer.
1
Plug the mains cable into the so-
cket (230V ~ , 50/60 Hz).
Caution:
The device is connected to the
7
mains with the power plug. To
fully disconnect the device from
the mains, pull out the plug.
The mains plug is used to dis-
7
connect the device. It shall
remain readily operable and
should not be obstructed during
intended use.
________________________________
Inserting the back-up
battery
During mains operation, the back-up
battery ensures that stored settings
are not lost in the case of a power
failure or when the device is briefly
disconnected from the mains.
1
Open the battery compartment lid
by pressing on the arrow and pus-
hing down the lid.
2
When inserting the battery (9 V,
6LF 22), observe the polarity mar-
ked on the base of the battery com-
partment.
Note:
Remove the back-up battery
7
when it is flat or when you know
that the device will not be used
for a long period of time.

Environmental note:

Batteries, including those which
7
do not contain heavy metal,
should not be disposed of
with household waste. Always
dispose of used batteries in
accordance with local environ-
mental regulations.
ENGLISH 19