Ad-Hoc Mode - Hama 00062765 Bedienungsanleitung

Preferred access points
Click this button to enter the MAC addresses of your preferred wireless LAN in the subsequent screen.
If your network uses encryption, switch to the Security tab and continue configuration on page 23 under
Setting wireless LAN encryption.
If your network is not encrypted, click OK to accept the settings! In the Profile management tab, you can now
select your profile and activate it by clicking the button.
3.1.2 Operation in ad-hoc mode
First enter a profile name, e.g. "My_profile". In the client name field, the name of your PC is entered automatically.
If you have selected version 1, you must now enter the SSID of the target network in the SSID1 field. This is
in the wireless LAN settings in your router or access point or you can ask the person in charge. If you have
selected version 2, the SSID has already been copied automatically from the scanned list.
Switch to the Advanced tab.
In general, all other values here can be left at the default settings. The individual items are described briefly
below.
Transfer power level:
You can reduce the power level. This may be practical if your WLAN devices are quite close to one another.
Wireless mode:
2.4 Ghz 54 Mbit/s:
2.4 Ghz 11 Mbit/s:
Super G ™ :
eXtended Range (XR) ™: Recommended if the router/access point or other devices in the network support
QoS:
22
Activate this option to support 802.11g standard devices at 54 Mbps (recommended)
Activate this option to guarantee compatibility to 11 Mbps devices (recommended)
Recommended if the router/access point or other devices in the network support
this mode.
this mode.
Support for bandwidth reservation (seldom required)
Network type:
Select Ad-Hoc. This mode allows you to connect to other
wireless LAN client devices, e.g. USB sticks, PCI cards or
card bus.
Wireless mode when starting the ad-hoc network:
Select whether you want to start ad-hoc mode at 11 Mbps
or 54 Mbps. Of course, this depends on the transfer rate
supported by the other devices in the network. Next, select
the channel to be used for your ad-hoc network. This chan-
nel must also be set for other devices in the network.