Faller 161349 Bedienungsanleitung Seite 30

Charging vehicles
Prerequisite condition: the charging unit is connected.
Fully discharge the vehicle by turning it upside down and leaving it swit-
X
ched on until its wheels come to a standstill.
Switch the vehicle off.
X
Fig. 3: Connecting the charging cable to the charging unit
Insert the plug located at one end of the charging cable into the socket
X
EN
of the charging unit, see Fig. 3.
Insert the plug located at the other end of the charging cable into the
X
socket located on the underside of the vehicle.
Press the key »Car 1«.
X
The charging procedure will begin. Both LEDs »Car 1« and »laden«
light up.
LED »Car 1« flashes once every minute to check the state of the rechar-
geable battery.
When LED »voll« lights up, the rechargeable battery is fully charged.
LED of the F0-F4 keys show the status of the charging procedure:
LED/Keys
»F0«
»F1«
»F2«
»F3«
»F4«
Tab. 2: Status of charging procedure
Disconnect the charging cable from the vehicle and from the char-
X
ging unit.
30
Status of charging procedure
Check if battery is wrong or if battery's polarity is
reversed
Start charging procedure
Check battery's voltage
Read charging CV from vehicle (only digital vehicles)
Charge rechargeable battery