Setting Up The Unit; Cookware; Operating The Unit - Westfalia 13 09 14 Bedienungsanleitung

Setting up the Unit

Place the unit on a stable and level surface. Never place the unit on a
flammable surface (e.g. table cloth, carpet, etc.). Do not place the unit on a
metal table.
Do not block or cover the ventilation slots (8) and the ventilator (7) of the unit.
This may overheat the unit. Also keep sufficient distances to the ceiling, walls
or other items.
Do not place the induction hotplate next to units or objects, which react
sensitively to magnetic fields (e.g. radios, TVs, cassette recorders, etc.).
Do not place induction hotplates next to open fires, heaters or other sources
of heat.
Make sure that the mains connection cable is not damaged or squashed
beneath the unit. Make sure that the mains connection cable does not come
into contact with sharp edges and/or hot surfaces.

Cookware

Suitable cookwares are flat and magnetic pans and pots, which is made from
cast iron of steel. If a magnet sticks on the bottom, the cookware can be
used. Stainless steel, cast iron, enamelled pans, flat-bottom pans and pots
with a diameter of 12 to 26 cm can be used. Some 18/10 steel pans and pots
with magnetisable bottom can also be used.
The diameter of the cookware should be from 12 – 26 cm. You can also use
cookware with larger diameter, but the area larger than 26 cm will not be
heated up sufficiently.
Cookware made from 18/10 steel, aluminium, copper or glass cannot be use.
Pots/pans with a diameter of less than 12 cm or ceramic pots and cookware
with feet cannot be used.

Operating the Unit

1. Connect the unit to a separate electrical circuit. Plug the power plug into a
suitable outlet. On the display you will see the icon – L – and you will hear an
acoustic signal sound. Now the unit is in standby mode.
2. Place suitable cookware in the centre of the cooking plate (1).
3. Press the ON/STANDBY button (5) to turn on the induction hotplate. The
control LED (3) will start flashing and you will hear an acoustic signal sound.
Now press the button HEAT (4). The preset power stage 5 will be displayed.
With the rotary switch (6) you can change the settings at any time in a range
Operation
12